Hi there,

I set decimal precision to auto, 0 and 1. But it always shows 2 decimals. I’d expect to see only full percentage rounded, if decimal precision is set to 0?

Hi @dirk_s,

thank you very much for the feedback!

You have reported an exciting issue, which I actually caused.

The number of zeros in the donut / pie chart was initially linked to the number of zeros set for the values. However, this led to very strange results if, for example, 7 zeros were selected for small values and then the percentages also got 7 zeros. We have therefore specified that in this case the percentages are always rounded to 2 zeros and the setting is only for the values.

A separate menu for separate zeros for percentage seemed excessive to us.

What would be your suggested solution to the problem? Theoretically, we could link to the setting and set a maximum of 2 zeros for the percentages.

Kind regards

Leo

Thanks for the explanation. Ok, understand… actually I think that between precision in the values and precision in the display there is indeed a difference and maybe should be defined separately. Not use how many other scenarios are there - its just this one, where its to precise for the chart.

Nothing is perfect. I guess this should probably have a low priority.